These pumps for buckets and drums offer quick and easy pumping, and some models provide filtration to condition lubricants and prevent expensive equipment failure and downtime. All pumps include a gas- and oil-resistant hose with brass fittings (most models) or nylon fittings (DEF models only) and a hose latch on the head to keep the fittings and cap off the ground. The pumps seal to the bucket or drum to prevent spills and contamination. All pumps, except DEF models, can pump five gallons in approximately 2-1/2 minutes, even through a filter. The DEF models pump one quart of DEF in four strokes.
All machinery, equipment, or vehicles that use diesel exhaust fluid can be quickly filled using the DEF pumps. The D10 accessory comes attached to the pump's hose and includes a cap and a ball valve shut-off.
The lubrication filter pumps work well with many petroleum-based or synthetic oils such as transmission fluid, motor oil, hydraulic fluid, turbine oils, 80/90 weight gear oils, and double 00 greases. The 5 gallon pumps also feature a handle lock to prevent side-to-side motion during use. An A10 hooked stainless steel filling spout with a ball valve shut off, and cap is included on some models.
The anti-freeze and coolant pumps are specifically designed for low-viscosity fluids, like anti-freeze and other coolants; any machinery, equipment, or vehicles that use these fluids can be filled quickly with these pumps.
Static-dissipating filter pumps are used where static discharge can be harmful or fatal. When used properly, the pump should dissipate static electricity safely through one of two grounding methods. The hose is the primary grounding method, with an internal grounding wire soldered to the fittings on both ends of the hose. The second grounding method is the external 4' grounding wire with an alligator clip. An A10 hooked stainless steel filling spout with a ball valve shut-off and cap is included. Note: This pump should not be used with gasoline or other flammable fluids.
Accessories like replacement filters, filter assemblies, A10 filling spout, and male and female quick disconnects are sold separately.
- DEHP vinyl hose; PVC inside tube
- Acetal rod & handle; ABS molds
- Stainless steel flapper & pin
- Stainless steel ball check valve (DEF models only); Chrome ball check valve (All other models)
- Nylon fittings (DEF models only) or brass fittings (All other models)
- DEF models have a CPVC fill spout
- Standard & static-dissipating models have a ten-micron nominal filter with no bypass
- For metal or plastic buckets, barrels & drums
- Dimensions: 1.313" Dia. Tube x 3/8" Dia. Hose
- Temperature range: 0°F to 140°F